Rear

Rear Brakes, AWD, Assembly Overview





1 - Hex socket head bolt - 65 Nm

2 - Brake carrier

^ With guide pins and protective cap
^ Supplied as replacement part assembled with sufficient grease on guide pins
^ Install repair kit in the event of damage to protective caps; use pad provided to grease guide pins.

3 - Bolt - 35 Nm

^ Self-locking
^ Replace each time after removing
^ When loosening and tightening counter hold on guide pin

4 - Brake hose/line

^ With banjo bolt and seals
^ After unscrewing banjo bolt, replace banjo bolt with angled sealing element
^ Tighten banjo bolt to 38 Nm

5 - Brake caliper housing

6 - Brake pads

^ When worn always replace both sides

7 - Pad retaining springs

^ Always replace when changing pads

8 - Backing plate

9 - Bolt - 10 Nm

10 - Brake disc

^ Never remove brake discs from hub by force. If necessary use penetrating fluid, otherwise brake discs can be damaged.
^ When worn always replace both sides

11 - Phillips-head screw - 4 Nm

12 - Wheel hub with rotor

13 - Circlip

14 - Wheel bearing

15 - Trailing arm

16 - Speed sensor

17 - Hex head bolt

18 - Parking brake cable