Removing & Installing

Removing





- Clamp rear final drive in assembly fixture.





- Remove hex nut for flange / drive shaft.
A - Hex head bolts M10 x 20

Note: When loosening hex nut, counter hold flange / drive shaft over tube - C - using transmission holder 2004 (2nd technician).





- Remove flange for drive shaft. Use three arm puller (e.g. Kukko 12-1) if difficult to access.
- Remove seal using extractor lever VW 681.

Installing
- Before installing, lightly coat new seal on outside circumference and between sealing lips for Haldex clutch with high performance oil G 052 175 A1.





- Drive in new seal flush.
- Install drive shaft flange.





- Insert new hex nut with D 000 600 and tighten to 220 Nm.

A - Hex head bolt M10 x 20

Note: When tightening hex nut, counter hold flange / drive shaft over tube - C - using transmission holder 2004 (2nd technician).

- Install rear final drive Installing.
- Check oil level in Haldex clutch.