Check DTC Memory (Scan Tool Function 02)

Check DTC Memory (Function 02)

NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.

- Switch printer on via the PRINT button (indicator lamp in button lights up).

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2-. This selects "Check DTC Memory", function 02.

Indicated on display:

Rapid data transfer Q
02 - Check DTC Memory

- Press -Q- button to confirm input.

Display indicates the number of stored malfunctions.

X malfunctions recognized!

The stored malfunctions are displayed and printed out in sequence.
- Check print-out against DTC table and repair malfunction. Navigation System Nav 4 (BNS 4.0), On-Board Diagnostic (OBD)

If "No DTC recognized" is displayed, the program will return to the start position after the button is pressed.

No malfunction recognized! ->

Indicated on display:

Rapid data transfer HELP
Select function XX

If something else is displayed:
See Operating instructions for Scan Tool (ST)

- End Output (function 06). End Output (Scan Tool Function 06)
- Switch off ignition and disconnect data link connector.