Shift Linkage: Testing and Inspection

Selector Lever Cable, Checking And Adjusting

Checking
- Place selector lever in "P" position.







- Pry selector lever cable -1 - from lever/selector shaft - 3 - e.g. with AF10 open end wrench - 2 -.
- Press catches on selector lever cable bracket together - arrows - and remove selector lever cable from bracket/transmission.
- Position selector lever cable so that the end can move freely.
- Do not bend or kink selector lever cable.
- Shift selector lever from "P" to "S".
- Check front shift boot on selector lever cable for damage, replace cable if necessary.
- Place selector lever in "P" position.
- Shift mechanism and selector lever cable must run smoothly when shifting. Replace selector lever cable or repair shift mechanism. if necessary.
- Carefully press selector lever cable on lever/selector shaft and insert in bracket/transmission.

Adjusting
- Place selector lever in "P" position.







- Loosen screw - 2 - on front ball socket of selector lever cable -1 -.
- Place lever/selector shaft - 3 - at transmission in "P". Stop lever must engage in park locking wheel, both front wheels are blocked (cannot be turned together in any direction).
- Tighten screws - 2 - (13 Nm).
- Shift mechanism, checking, Testing and Inspection