Oxygen Sensors Assembly Overview

Oxygen Sensors Assembly Overview

- 1 - Heated Oxygen Sensor (G39) connector





Heated Oxygen Sensor (G39) - arrow -





Connector - arrow - on the Oxygen Sensor after Three Way Catalytic Converter (G130)





Oxygen Sensor after Three Way Catalytic Converter (G130) - 1 -





• New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

• For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with sensor slots. Hot bolt paste, refer to the electronic parts catalog ETKA

• Electrical wire of oxygen sensor must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.

• Tightening specifications: 55 Nm

Heated oxygen sensor (G39) and oxygen sensor heater (Z19), Removing and Installing. Refer to=> [ Heated Oxygen Sensor and Oxygen Sensor Heater before Catalytic Converter ] Heated Oxygen Sensor and Oxygen Sensor Heater Before Catalytic Converter.

Oxygen sensor after three way catalytic converter (G130) and heater for oxygen sensor 1 after catalytic converter (Z29), removing and installing. Refer to => [ Oxygen Sensor after Three Way Catalytic Converter and Oxygen Sensor 1 Heater ] Oxygen Sensor After Three Way Catalytic Converter and Oxygen Sensor 1 Heater.