Clutch Housing

Clutch Housing

Special tools, testers and auxiliary items required

• Punch (VW 407)

• Drift (T10169)

• - 1 - Internal Puller 14.5 to 18.5 mm (Kukko 21/2) and internal Puller 23.5 to 30 mm (Kukko 21/4)

• - 4 - Counter-Support (Kukko 22/1) and (Kukko 22/2)

Pulling Out Bearing Bushing for Selector Rod





A Counter support (Kukko 22/1)
B Internal Puller 14.5 to 18.5 mm (Kukko 21/2)

Driving in Bushing for Selector Rod to Tool Stop





- Drive in bushing up to the stop when tool makes contact.

Pulling Needle Bearing Out of Clutch Housing





A Counter Support (Kukko 22/2)
B Internal Puller 23.5 to 30 mm (Kukko 21/4)

• Needle bearing is destroyed when it is removed and must be replaced.

Needle Bearing - A -, Pressing Into Clutch Housing





- During pressing sequence, place thrust washer - B - for reverse shaft onto the needle bearing - A -.

Press Axle for Reverse Gear Shift Fork Into Clutch Housing