Driver Side Knee Bar

Driver Side Knee Bar






1 Central Tube

2 Bolt

9 Nm

3 Right Knee Bar

• Removing

- Remove driver side storage compartment. Refer to => [ Driver Side Storage Compartment ] Driver Side Storage Compartment.

- Remove bolts - 2 - and - 4 -.

- Remove knee bar on central tube - 1 -.

• Installing

To install, perform the steps used in removal in reverse order.

4 Bolt

9 Nm

5 Bolt

9 Nm

6 Bolt

9 Nm

7 Left Knee Bar

• Removing

- Remove driver side storage compartment. Refer to => [ Driver Side Storage Compartment ] Driver Side Storage Compartment.

- Remove Left Vent Temperature Sensor (G150) => [ , removing and installing ].

- Remove the bolts - 5 -, - 6 - and - 8 -.

- Remove wiring bracket.

- Remove knee bar on central tube - 1 -.

• Installing

To install, perform the steps used in removal in reverse order.

8 Bolt

9 Nm

Left Vent Temperature Sensor (G150), removing and installing





Removing

- Rotate Left Vent Temperature Sensor (G150) - B - 90° in - direction of arrow -.

- Remove Left Vent Temperature Sensor (G150) from air duct.

• The electronic connector - A - must not be disconnected.

Installation

Installation is reverse of removal, but note the following:

- Be careful not to pinch the seal when turning the - C - Left Vent Temperature Sensor (G150)