Rear Final Drive 02D and 0AV, Electric and Electronic Components and Installation Location

Rear Final Drive 02D and 0AV, Electric and Electronic Components and Installation Location






1 All-Wheel Drive Control Module (J492)

• Installed location

• Comprises a unit together with haldex clutch control valve (N373)

• A pressure sensor is also located in control module

• Important signals from engine control module and ABS control module (J104) are transmitted via data BUS to all wheel drive control module.

2 Haldex Clutch Pump (V181)

• Installed location

• Can be tested in guided fault finding with the vehicle diagnosis, testing and information system (VAS 5051B).

3 Data Link Connector (DLC)

• Installed location: left front footwell, near the hood release handle.

4 Parking Brake Switch (F9)

• Installed location

• Can be tested in guided fault finding with the vehicle diagnostic, testing and information system (VAS 5051).

5 Brake Light Switch (F)

• Installed location

• Can be tested in guided fault finding with the vehicle diagnosis, testing and information system (VAS 5051B).

All-Wheel Drive Control Module (J492)

Installed location: the control module - A - is located on front of the rear final drive on the left side.





Haldex Clutch Pump (V181)

Installed location: the Haldex clutch pump - arrow - is located on the front of the rear final drive on the right side.





Brake Light Switch (F)





Installed location: the brake lamp switch (F) is located on pedal assembly above the brake pedal.

Parking Brake Switch (F9)

Installed location: the switch - arrow - is located on parking brake lever.