Electric and Electronic Components and Installation Locations, Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV)

Electric and Electronic Components and Installation Locations, Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV)






1 All Wheel Drive (AWD) Control Module (J492)

• Important signals are transmitted from the Engine Control Module (ECM) and ABS control module (J104) via data BUS to the AWD control module.

• Assembly overview, refer to => [ All Wheel Drive Control Module (J492), Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV) Overview ] All Wheel Drive Control Module (J492), Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV) Overview

• Removing and installing, refer to => [ AWD Control Module (J492), Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV) ] AWD Control Module (J492), Rear Final Drive 0BR, 0BS and 0BY (Haldex-Clutch Generation IV)

2 Haldex Clutch Control Valve (N373)

3 Haldex Clutch Pump (V181)

• Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester

• Removing and installing, refer to => [ Haldex Clutch Pump (V181), Final Drive 02D/0AV ] Haldex Clutch Pump (V181), Final Drive 02D/0AV

4 Data Link Connector (DLC)

• Installed location: Front left footwell

5 Accelerator Pedal Position Sensor (G79)