Headlamp Beam Adjustment Motors, Through MY 2006

Headlamp Beam Adjustment Motors, through MY 2006

CAUTION!
Danger to life due to high voltage.

• Usage and safety information for gas discharge headlamps. Refer to => Lighting and Horns

Removing





- With ignition switched off, disconnect battery Ground (GND) wire.

- Remove headlamp. Refer to => [ HID Headlamp, through MY 2006 ] Headlamps, Through MY 2006.

- Release the spring clip - arrows - and remove the cover from the headlamp housing.

- Remove screws - arrows -.





- Push out ball head of adjustment axle by swinging adjusting motor - 2 - to the side out of ball head mount.

- Disconnect electrical connector - 1 -.

Installing

Install in reverse order of removal, observing the following:

- Install headlamp.

- Connect battery.

• Always adjust headlamps after removing, installing or replacing adjustment motors .

Tightening Specifications