ATF Pipes

ATF Pipes

Special tools, testers and auxiliary items required

• Oil Collecting and Extracting Device (V.A.G 1782 )

• Plug Set, Engine (VAS 6122)

• Protective glasses

• Observe cleanliness rules when working on automatic transmissions. Refer to => [ Cleanliness Working Conditions ] Cleanliness Working Conditions.

• Thoroughly clean all connections and the surrounding area before disconnecting.

Removing

- Mark all corresponding ATF lines in color to prevent mix-ups.

- Place the Oil Collecting and Extracting Device ( V.A.G 1782) the separating joint.

CAUTION!
Wear protective glasses.

- Disconnect ATF lines.

- Seal any open lines and connections with a clean plug from the Engine Plug Set (VAS 6122).

Installing

Install in reverse order, paying attention to the following:

- Clean ATF lines. Refer to => [ ATF Lines and Cooler, Cleaning ] 01V,01VA Transmission.

- Replace the O-rings and coat to ATF.

- Insert ATF lines by hand completely into transmission or cooler as far as stop and then tighten.

- Check and correct ATF level in planetary gearing. Refer to => [ ATF Level In Planetary Gearing, Checking and Correcting ] ATF Level In Planetary Gearing, Checking and Correcting.