Evaporative Emissions System

Hose Routing, EVAP Canister/Leak Detection System, 6-cyl. MPI-Engine





1 Throttle valve control module (J338)

2 Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)

• Component location: Right front in engine compartment

3 Vent line

• From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)

• Installation position: At right beneath vehicle floor

• Secured to fuel tank in fuel tank area

4 Vent line

• To gravity valve at fuel tank

5 EVAP canister

• Component location: Bottom of spare wheel well

• Removing and installing, refer to => [ EVAP Canister ] Service and Repair

6 Connecting hose

• Leak detection pump/EVAP canister

• Pressure side

7 Air filter housing

• For Leak Detection Pump (LDP) (V144)

8 Leak Detection Pump (LDP) (V144)

• Component location: In left rear wheel housing behind wheel housing liner

• Check using "Guided Fault Finding"

• Checking, refer to => [ Leak Detection Pump, Checking, Vehicles with MPI Engine ] Leak Detection Pump, Checking, Vehicles With MPI Engine

• Removing and installing, refer to => [ Leak Detection Pump ] Service and Repair

9 Vacuum line

• To Leak Detection Pump (LDP) (V144)