Multi-Function Transmission Range Switch

Multi-Function Transmission Range Switch

Removing

- Remove left front wheel.

- Removing left transmission support. Refer to => [ Left and Right Transmission Supports ] 01V,01VA Transmission.

- Disconnect electrical connector - 1 - on Multi-Function Transmission Range (TR) Switch (F125).





• Disregard - 2 -.

- Remove Multi-Function Transmission Range (TR) Switch (F125) - arrows -.





- Remove the Multi-Function Transmission Range (TR) Switch (F125) from the selector shaft.

Installing

Install in reverse order, paying attention to the following:

- Connect Multi-Function Transmission Range (TR) Switch (F125) to shift rod. Flat part at splines in switch - 3 - must align with flat part of shift rod - 1 -.





• Attach Multi-Function Transmission Range (TR) Switch (F125) centrally on selector shaft. Do not distort and do not use excessive force. This may damage switch contacts.

- Rotate switch until the alignment bore - 4 - at switch housing can be fitted on the alignment pin - 2 - at transmission housing.

- Install left transmission support. Refer to => [ Left and Right Transmission Supports ] 01V,01VA Transmission.

- Mount the left front wheel.

Tightening Specifications