Fuel Tank With Attachments As of 07.03, Assembly Overview
Fuel Tank With Attachments As Of 07.03, Assembly Overview
1 - Fuel line
- From fuel filter
- To engine
- Do not bend
- To disconnect, press release button on connection piece
2 - Vent line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- Do not bend
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
3 - Electrical harness connector
- For fuel tank lock switch
4 - 2 Nm
5 - Heat shield
- For fuel filler tube
6 - 23 Nm
- Serves to secure fuel filler neck and Ground (GND) connection
7 - Overflow hose
- Engaged in wheelhousing
8 - Rubber top
9 - Tensioning ring
10 - Seal
- Replace if damaged
11 - Cap
12 - Ground (GND) connection
- For discharging electrostatic charge
- Installed position / check requirements
- Make sure secure seating of connector and secure wire with securing bolt for fuel filler tube
- After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using Ohm meter. Specified value: approx. 0 Ohms
13 - Vent line
14 - Vent line
- From gravity valve to EVAP canister
- To remove, press release ring on EVAP canister
15 - Vent line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- To remove, press release ring on EVAP canister
- Clipped in on fuel tank
16 - Fuel tank
- Empty if necessary, to remove components
17 - Heat shield
- For fuel tank
18 - 2 Nm
19 - Heat shield
- For fuel tank
20 - 2 Nm
21 - Expanding clip
22 - Tension strap
- Note varying lengths
23 - 23 Nm
Fig. 1 Installation position of Ground (GND) connection
- Route Ground (GND) connection as shown in figure.
- Engage contact -1- of Ground (GND) connection into securing opening on fuel tank -5- and then press in spacer bushing -2-.
- Make sure connector -4- of Ground (GND) connection fits securely at metal ring -3- of fuel filler tube.
CAUTION:
After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using Ohm meter:
- Specified value: approx. 0 Ohm.