Oil Pressure Sender: Service and Repair

Oil Pressure Switch

Special tools, testers and auxiliary items required

• Old oil collecting and extracting device (V.A.G 1782 )





Removing

- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen screws or quick-release fasteners - 1 - and - 2 - and remove front noise insulation.





- Remove quick-release fasteners - 3 - and remove rear noise insulation, if installed.

- Disconnect electrical harness connector from Oil Pressure Switch (F1) - arrow -.





- Unscrew oil pressure switch.

Installing

Installation is performed in reverse order of removal, noting the following:

• Replace seal.

- Add engine oil and check oil level. Refer to => [ Oil Level, Checking ] Testing and Inspection.

Tightening Specifications