Planetary Drive 3

Planetary Drive 3

Disassembling

- Remove ring gear "III" with shaft - 5 - from planetary carrier "III" - 1 -.





- Remove angle washer - 4 -, axial needle bearing - 3 - and thrust washer - 2 -.

Assembling

CAUTION!
Before assembling, check components of planetary gear "III" for wear and damage. Refer to => [ Planetary Drive 3 ] Planetary Drive 3.

- Attach the following components onto shaft of planetary carrier " III" - 1 -:

2 Thrust washer
3 Axial needle bearing
4 Angle washer - angled edge points toward axial needle bearing

- Position ring gear "III" with shaft - 5 - on planetary carrier "III" - 1 -.