Torsen Housing Assembly Overview

Torsen Housing Assembly Overview

• The flange shaft => [ (Item 1) Flange shaft ] was made with a groove for replacing a sealing ring with an additional dust lip (as of serial number 42987), refer to => [ Differentiation of sealing rings ] Torsen Housing Allocate components via the.





1 Flange shaft

• Press off, refer to => [ Press off flange shaft (torsen housing with vibration dampener) ] Torsen Housing or => [ Press off flange shaft (torsen housing without vibration dampener) ] Torsen Housing

• Pressing in, refer to => [ Pressing in flange shaft ] Torsen Housing

• Change: as of serial number 42987 with groove, refer to => [ As of serial number 42987 - Flange shaft with
nut and sealing ring with additional dust lip ] Torsen Housing

2 Screw - 20 Nm + an additional 90°

• For vibration dampener.

• Quantity: 3

• Self-locking.

• Replace.

3 Vibration dampener

• Not present on all versions.

4 Seal

• Removing, refer to => [ Pry off sealing ring ] Torsen Housing

• Installing up to serial number 42986, refer to => [ Sealing ring - up to serial number 42986 - installing ] Torsen Housing

• Change: as of serial number with additional dust lip, refer to => [ Differentiation of sealing rings ] Torsen Housing

• Installing as of serial number 42987, refer to => [ Sealing ring - as of serial number 42987 - with additional dust lip, installing ] Torsen Housing

5 Torsen housing

• Assembly overview, refer to => [ Torsen Differential Assembly Overview ] Torsen Differential Assembly Overview.

• Removing and installing with transmission installed..

6 Ball bearing

• For flange shaft.

• Pressing out, refer to => [ Pressing out ball bearing for flange shaft ] Torsen Housing

• Pressing in, refer to => [ Pressing in ball bearing for flange shaft ] Torsen Housing

7 Circlip