Parking Brake Lever With Liner

Parking Brake Lever with Liner

Removing

- Remove the center console extension.

- Release the handle - 1 - with a screwdriver - 3 - and remove.





- Remove the cover - 4 - and handle - 1 -.





- Remove the bolts - 2 - and remove the carrier - 1 -. (Bolt tightening specification: 6 Nm).





- Remove the floor covers.

- Remove the left floor trim approximately (8 bolts).

- Remove the inner floor trim at exhaust pipe

- Detach the rear exhaust pipe.

- Remove the heat shield at the rear of the fuel tank.

- Detach the rear tunnel heat shield.

- Disconnect the parking brake contact switch.

- Remove the bolts - 3 and 4 -.





- Remove the parking brake lever downward.

- Remove the collar nuts - 1 -. (Nut tightening specification: 25 Nm).





- Remove the parking brake lever - 2 - from the plate.

Reset the adjusting mechanism

- Clamp one of the spring loaded hooks in a vise.





- Release the mechanism with a screwdriver - 2 -, at the same time pressing back the second spring loaded hook with another screwdriver.

Installing

Installation is in reverse order of removal.

- Insert the parking brake cable into the compensator. (vehicles with Front Wheel Drive (FWD)).





- Insert the parking brake cable into the compensator. (vehicles with All Wheel Drive (AWD)).





- Tighten the bolt - 3 -. Tightening specification: 25 Nm





- Tighten the adapter with washer - 4 -. Tightening specification: 25 Nm

- Install the center console extension.

- Adjust the parking brake. Refer to => [ Parking Brake Adjusting ] Parking Brake Adjusting.