DTC Memory, Erasing

DTC Memory, Erasing

Requirements:

• DTC memory scanned => [ DTC Memory, Checking ] DTC Memory, Checking.

• All malfunctions corrected.

After DTC scan has been checked:

Display on (VAS5051):





- In selection touch - 1 - diagnostic function " 05 - Delete DTC memory".

Display on (VAS5051):





1. <> No display (before deletion)

or

<> DTC memory deleted

• If the message appears in display field - 1 -: " DTC memory has not been scanned yet", the test procedure was not followed exactly. The DTC memory can only be deleted if the DTC memory was scanned previously.

2 Note: Are you sure you want to do this? Note: Data will be deleted!

- Touch OK button in display - 2 -.

- End function "05 - Delete DTC memory" by touching arrow button.

- After repair scan DTC memory again.

• This deletes DTCs which were stored during repair of the fault, for example by removing harness connectors.

- After scanning and deleting DTC memory, test drive vehicle and scan DTC memory again.

The scan of the DTC memory must display:

"No DTC recognized"