General Information

General Information

CAUTION!
• Servicing with the incorrect number of lining discs leads to input shaft damage after bringing vehicle into operation again.

• In this case, the software in the Transmission Control Module (TCM) (J217) does not match the number of lining discs.

There are two types of transmissions. They are differentiated according to transmission code.

1. Transmission with 7 lining discs serviced

These transmissions are installed in vehicles with a 6 cylinder 3.0L MPI engine and a 3.2L FSI engine. Refer to => [ General Information ] General Information.

2. Transmission with 6 lining discs serviced

These transmissions are installed in vehicles with all other engines.

• Input shaft with 6 lining discs assembly overview. Refer to => [ Input Shaft with 6 Lining Discs Assembly Overview ] Input Shaft With 6 Lining Discs Assembly Overview.

• Input shaft with 6 lining discs disassembling and assembling. Refer to => [ Input Shaft with 6 Lining Discs ] Input Shaft With 6 Lining Discs.

• Input shaft adjusting with air gap determination. Refer to => [ Input Shaft Adjusting with Air Gap Determination ] 01J Transmission.