Transmission Cover Assembly Overview

Transmission Cover Assembly Overview





1 Transmission cover

2 Alignment pin

• Quantity: 2

• Place in transmission cover.

• Drive in flush to rear side of housing joint surface.

3 Needle bearing

• For hollow shaft mounting in transmission cover.

• Pressing out, refer to => [ Press needle bearing out of transmission cover ] Transmission Cover

• Pressing in, refer to => [ Press needle bearing into transmission cover ] Transmission Cover

• Secure after installing with peen, refer to => [ Secure needle bearing and roller housing in transmission cover with peen ] Transmission Cover

4 Ball sleeve

• For reverse gear selector rod.

• Pulling out, refer to => [ Remove ball sleeve from transmission housing ] Transmission Cover

• Pressing in, refer to => [ Press ball sleeve into transmission cover ] Transmission Cover

• Measure press in depth, refer to => [ Ball sleeve press-in depth in transmission cover ] Transmission Cover

5 Ball sleeve

• For selector rod for 1st and 2nd gear.

• Pulling out, refer to => [ Remove ball sleeve from transmission housing ] Transmission Cover

• Pressing in, refer to => [ Press ball sleeve into transmission cover ] Transmission Cover

• Measure press in depth, refer to => [ Ball sleeve press-in depth in transmission cover ] Transmission Cover

6 Roller sleeve

• For input shaft mounting in transmission cover.

• Always replace.

• Pulling out, refer to => [ Remove roller sleeve from transmission cover ] Transmission Cover

• Pressing in, refer to => [ Carefully press new roller sleeve into transmission cover to stop. ] Transmission Cover

• Secure after installing with peen, refer to => [ Secure needle bearing and roller housing in transmission cover with peen ] Transmission Cover