Oil Pressure Sender: Service and Repair

Oil Pressure Switch

Removing

- Remove rear engine cover - arrows -.





- Remove coolant expansion tank - arrow -.





- Disconnect electrical connection from Engine Coolant Level (ECL) Warning Switch (F66) at bottom of coolant reservoir and set aside coolant reservoir with coolant hoses - 1 - and - 2 - connected.

• Place a rag under oil filter housing to catch escaping engine oil.

- Disconnect electrical harness connector from Oil Pressure Switch (F1) - arrow -.





- Unscrew oil pressure switch.

Installing

Installation is in reverse order of removal, noting the following:

• Replace seal.

- Check oil level.

Tightening Specifications