Four-Way Lumber Support, Removing and Installing - Up to 06.06

Four-way Lumber Support, Removing And Installing-up To 06.06

Special tools, testers and auxiliary items required

- Special pop rivet pliers V.A.G 1753 A







1 - Backrest padding
2 - four-way lumbar support
3 - Clamping sleeve
4 - Four-way lumbar support frame

- Removing:
- Remove backrest cover panel.
- Pry fastening strips - 10 - (4x) out with a screwdriver.
- Insert foil between upholstery and backrest frame to protect against metal particles.
- Drill out rivet - 7 -.
- Disengage four-way lumbar support frame - 4 - at upper left and right from backrest frame.
- Disconnect electrical harness connectors at actuators - 5 - and - 9 - for four-way lumbar support.
- Disconnect Velcro connector between four-way lumber support - 2 - and backrest upholstery - 1 -.
- Disengage four-way lumbar support at top of frame.
- Remove four-way lumbar support.

- Installing:
Installation is performed in reverse order of removal, noting the following:
- Place a plastic film over Velcro strips on four-way lumbar support. Secure plastic film to four-way lumbar support.
- Ensure four-way lumbar support is secured to frame with transport fastener or a suitable pin.
- Position lumbar support frame behind backrest and engage lumbar support frame at top left and right in mounts on frame.
- Rivet bottom of four-way lumbar support frame with backrest frame. A plastic washer must be placed between four-way lumbar support frame and backrest frame.
- Remove plastic film between backrest padding and four-way lumbar support.
- Press four-way lumbar support Velcro fastener onto backrest padding to secure.
- Connect electrical connectors to four-way lumbar support adjustment motors.
5 - Four-way lumber support positioning motor
6 - Assembly safety guard
For centering four-way lumbar support with frame
7 - Rivet
- Rivet using special pop rivet pliers V.A.G 1753 A
- Before riveting, a plastic washer must be placed between four-way lumbar support and backrest frame
8 - Plastic washer
9 - Four-way lumbar support height adjustment motor
10 - Fastening strips







Secure four-way lumbar support with assembly aid and secure plastic film to four-way lumbar support.
- Lay plastic film - 1 - over Velcro strips - 2 - on four-way lumbar support. Secure plastic film to four-way lumbar support.
- Ensure four-way lumbar support is attached to four-way lumbar support frame with assembly fastener - 3 - or a suitable pin.







Four-way lumbar support with backrest frame, riveting
- Before securing rivet - 4 -, a plastic washer - 1 - must be placed between four-way lumbar support - 2 - and backrest frame - 3 -.