Seat Height Adjustment Handle

Front Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Seat Height Adjustment Handle





1 - Seat Height Adjustment Handle

• Removing

- Remove seat.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Create an assisting tool. Refer to => [ Create Assisting Tool to Remove Seat Height Adjustment Handle ].

- Pull seat height adjustment handle - 1 - away from seat a little.

- Guide assisting tool - 2 - into mount - 4 -.

- Pull assisting tool - 2 - in direction of arrow - A - to push spring - 3 - back.

- Pull seat height adjustment handle - 1 - in - direction of arrow B -.

• Installing

- Ensure retaining clamp is positioned on seat height adjustment handle lever. Note installation position => [ Retaining Clamp Installation Position ].

- Install the seat height adjuster handle - 1 - in reverse order of removal.

2 - Assisting Tool

3 - Spring

4 - Mount

Create Assisting Tool to Remove Seat Height Adjustment Handle





- Bend a screwdriver - 1 - with a width - 2 - of 3.5 mm and dimensions - A - 20 mm and - B - max. 15 mm.

Retaining Clamp Installation Position





- Ensure springs - 2 - (Qty. 2) in retaining clamp - 3 - are positioned on outside of lever - 1 -.