Power Seat Height Adjuster, Bolted Upper Seat Section

Power Seat Height Adjuster, Bolted Upper Seat Section

• Old shoulder pin must be used.

• Old seat frame must be used.

• Old sail must be used on new height adjuster gearing.

• New microencapsulated bolts to secure the sail to the height adjuster gearing and to the seat rail are included in delivery.

• New nut to secure shoulder pin and plastic toothed segment are included in delivery.

- Move seat as far to front as possible.

- Remove side trim on sill side. Refer to => [ Side Trim, Sill Side ] Side Trim, Sill Side.





1 Seat

2 Bolts for Seat Rail (Microencapsulated)

- Remove two rear microencapsulated bolts - 2 - to seat rail on left and right.



- Loosen shoulder pin - 1 -, nut - 2 - and lever - 3 - on height adjuster gearing and remove shoulder pin - 1 -.





- Fold seat fully toward front.

- Remove height adjuster gearing.

- Remove both microencapsulated bolts - 1 - at sail to height adjuster gearing.





- Clean threaded holes on height adjuster gearing.

- Secure new height adjuster gearing to sail using both new microencapsulated bolts - 1 -.

• Always clean threaded holes for bolts (e.g. using a thread cutter).

- If damaged, replace white plastic toothed segment.

- Carefully insert height adjuster gearing and make sure white plastic toothed segment is not damaged.

- Guide shoulder pin through height adjuster gearing, sail and drive lever and tighten new nut.

- Clean threaded holes in seat rail.

- Fold seat fully toward rear.

- Secure seat to seat rail using microencapsulated bolts supplied.

• Always clean threaded holes for bolts (e.g. using a thread cutter).