Ribbed Belt Component Overview

Ribbed Belt Component Overview

• Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.





1 Ribbed belt

• Ribbed belt routing, refer to => [ Ribbed Belt, Routing ] [1][2]Diagrams

• Check for wear

• Do not kink

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

2 Pulley

• For ribbed belt

• Removing and installing, refer to => [ Crankshaft Pulley ] Crankshaft Pulley

3 Special bolt

• Replace

• Torque specification 10 Nm plus an additional 90°

4 23 Nm

5 Engine lift eye

6 Belt tensioner for ribbed belt

• To release tension on ribbed belt, pivot using open-end wrench.

• Secure tensioner with special tool Locking Tool ( T40098)

7 23 Nm

8 Bushing

9 Bracket for assemblies

• Removing and installing, refer to => [ Accessory Bracket ] Service and Repair

10 23 Nm

11 Generator

• Removing and installing, refer to => Starting and Charging Starting and Charging

• To facilitate installing the generator, slightly drive back threaded bushings for retaining bolts on generator.

12 23 Nm

13 Power steering pump

• Removing and installing, refer to => Steering Steering

14 45 Nm

• Insert with locking fluid

• Observe tightening sequence, refer to => [ Accessory Bracket ] Service and Repair

15 Bushing

• 2 pieces

16 Air conditioner compressor

• Removing and installing, refer to => Heating and Air Conditioning Heating and Air Conditioning

17 25 Nm

18 Idler roller for ribbed belt

• Note installation position

19 20 Nm plus an additional 90° (1/4 turn)

• Replace