Selector Lever and Locking Cable Assembly Overview

Selector Lever and Locking Cable Assembly Overview

• Do not bend or kink selector lever cable.

• Lubricate pull ring and ball socket with polycarbamide grease, part no. G 052 142 A2.





1 Selector lever cable

• Must not be kinked

• Removing and installing, refer to => [ Selector Lever Cable ] 01VA Transmission

• Adjusting, refer to => [ Selector Lever Cable, Checking and Adjusting ] 01VA Transmission

2 Lock nuts - 12 Nm

3 Boot

• For selector lever cable

• Fasten into bottom cover of shift mechanism

4 Locking clamp

5 Ignition/Starter Switch

• With ignition key removal lock

6 Locking cable

• For ignition key removal lock

• Must not be kinked

• Removing and installing, refer to => [ Locking Cable ] 01VA Transmission

• Adjusting, refer to => [ Locking Cable, Adjusting ] Adjustments

7 Hex-bolt - 9 Nm

8 Clamping screw - 13 Nm

• For selector lever cable

• To adjust, loosen by approx. 1 turn, do not fully remove

9 Pin

• For selector lever cable

• To remove selector lever cable, pull plastic securing spring on shift mechanism slightly forward and push pin up only as far as necessary

10 Retaining clip

• For selector lever cable

• Always replace

11 Pivot

• For selector lever cable to transmission

12 Hex-bolt, 23 Nm