Bearing Housing Assembly Overview

Bearing Housing Assembly Overview





1 Bearing housing

• Redetermine shim "S4" when replacing, refer to => [ Redetermining Shim S4 when Replacing Bearing Housing ] Redetermining Shim S4 when Replacing Bearing Housing.

2 Outer race

• For needle roller bearing on input shaft.

• Driving out, refer to => [ Driving outer race for needle roller bearing
out of bearing housing ] Bearing Housing

• Pressing in, refer to => [ Pressing outer race for needle roller bearing into bearing housing until limit stop ] Bearing Housing

3 Shim "S4"

• Table of adjustments, refer to => [ Adjustment Table ] Adjustment Table.

• Redetermine when replacing bearing housing, refer to => [ Redetermining Shim S4 when Replacing Bearing Housing ] Redetermining Shim S4 when Replacing Bearing Housing.

4 Tapered roller bearing outer race

• For output shaft.

• Removing and installing => [ (Item 25) Tapered roller bearing outer race ] Pinion Shaft Assembly Overview

5 Selector rod for 1st and 2nd gear

• Only replace together with selector fork for 1st and 2nd gear (secured together by means of a pin).

6 Reverse gear selector rod

7 Ball sleeve

• (Front) for reverse gear selector rod.

• Pulling out, refer to => [ Pulling front ball sleeve out of reverse gear selector rod ] Bearing Housing

• Pressing in, refer to => [ Pressing front ball sleeve into reverse gear selector rod until limit stop. ] Bearing Housing

8 Ball sleeve

• (Rear) for reverse gear selector rod.

• Pulling out, refer to => [ Pulling out rear ball sleeve for reverse gear selector rod ] Bearing Housing

• Pressing in, refer to => [ Pressing in rear ball sleeve for
reverse gear selector rod ] Bearing Housing

9 Selector rod for 3rd and 4th gear

10 Selector rod for 5th and 6th gear

• Remove burrs and scoring after removing from bearing housing.

11 Ball sleeve

• For selector rod for 5th and 6th gear.

• Pull out with internal puller (Kukko 21/2).

• Drive in until flush using guide pin (10 - 15).

12 Locking bushing

• For selector rod for 3rd and 4th gear.

• Removing and installing, refer to => [ Removing and installing locking bushing for selector rod ] Bearing Housing

13 Locking bushing

• For selector rod for 5th and 6th gear.

• Removing and installing, refer to => [ Removing and installing locking bushing for selector rod ] Bearing Housing

14 Ball sleeve

• For selector rod for 3rd and 4th gear.

• Pull out with internal puller (Kukko 21/2).

• Driving in, refer to => [ Driving in ball sleeve for selector rod for
3rd and 4th gear ] Bearing Housing