B-Pillar Trim Panel

B-Pillar Trim Panel







1 - B pillar trim panel

Removing:

• Unclip cover - 7 -.

• Remove bolts - 6 - pull trim panel off outward.

Installation:

• With rear door opened, guide trim panel into retaining bracket.

• With rear door closed, position at top and bottom according to magnified area in illustration.

• Screw in front bolt - 6 -.

• Outer lip of rear door window seal must make contact cleanly over entire range of trim panel.

• Excessive pressure on seal at trim panel must be prevented, otherwise the projecting lip may cause wind noise.

• With door opened, screw in rear bolt - 6 -.

• Press grommet - 5 - into trim panel.

• Slide cover - 7 - on from below.

2 - Bolt

• 1.5 Nm

3 - Retaining bracket

4 - Clip

5 - Grommet

6 - Combination bolt

• 5 Nm

7 - Cover