Procedures

Lock Carrier Service Position

• Do not remove noise insulation, only loosen front quick release screws => [ Noise Insulation Panel Assembly Overview ] Noise Insulation Panel Assembly Overview.

• Bumper removed.





1 - Lock carrier

• Service position

• Remove engine cover.

• Unscrew intake air duct between lock carrier and air cleaner housing at lock carrier and remove.

• On the left side, screw in special tool 3369 in threaded hole => [ Screw in special tool 3369 ]

• On the right side, screw in special tool 3369.

• Unscrew mounting bolts - 5 - at left and right.

• Unscrew mounting bolts - 4 - and pull lock carrier - 1 - toward front.

• Secure lock carrier => [ Secure lock carrier ].

2 - Left engine cover

3 - Right engine cover

4 - Combination bolt

• 10 Nm

5 - Combination bolt

• 50 Nm

• For service position, screw in special tool 3369.

• After assembly of lock carrier, check headlight positioning and adjust if necessary.

Screw in special tool 3369





- Screw in special tool 3369 left and right as shown.

- Pull lock carrier forward until rear hole in lock carrier aligns with front threaded hole in fender flange.

Secure lock carrier





- Secure lock carrier at left and right with bolts.