Storage Compartment, Disassembling and Assembling

Recaro Front Seats, from November 2004

• From August 2005, the conventional wiring harness routing to the connector station under the front seat. Refer to => [ Connectors, Disconnecting ] Connectors, Disconnecting has been replaced with modular wiring routing. Refer to => [ Modular Wiring Routing, from August 2005, Assembly Overview ] Standard Front Seat, From November 2004.

Storage Compartment, Disassembling and Assembling

- Remove storage compartment, refer to => [ Storage Compartment ] Recaro Front Seats, From November 2004.

Trim, Removing

- Using Trim Removal Wedge (3409), unclip trim - 1 - from retaining tabs - arrows - (Qty. 4) on inner part - 2 -.





Handle With Locking Mechanism, Removing

- Remove trim.

- Remove axle - 1 - from inner part - 3 -.





- Remove handle with locking mechanism - 4 -, torsion spring - 2 - and axle - 1 -.

Insert, Removing

• The insert is placed in the inner part and is not secured by any additional means.

• For overview purposed, the trim and handle with locking mechanism are not shown in the illustration.

- Open storage compartment.

- Remove insert - 1 - from inner part - 2 -.





Inner Part, Removing From Outer Part

- Open storage compartment.

- Press retainers - 2 - (Qty. 2) upward in - direction of arrow A -.





- Tip inner part - 1 - down in - direction of arrow B -.

- Remove outer part - 1 - from guide - arrow - on inner part - 2 -.





Storage Compartment, Assembling

Assembly is performed in the reverse order of removal. Observe the following when doing so:

- Engage torsion spring - 1 - so that shorter side - arrow A - is supported on inner part - 2 - and longer side - arrow B - is supported on handle - 3 -.