Compressor Drive Shaft

Compressor Drive Shaft

Removing

- Remove compressor, refer to => [ Compressor, 4- or 6-Cylinder ] Compressor, 4- or 6-Cylinder.

- Remove boot - A -





- Remove driveshaft - B - from splines of drive pinion - C -

Installing

Installation is carried out in the reverse order, when doing this note the following:

- Check driveshaft - B -, splines must show no traces of wear and must be seated free of play in splines of drive wheel - C -.

- Coat splines of driveshaft - B - using clutch splining grease G 000 100 before installing.

- Insert driveshaft - B - before installing compressor and slide it into drive wheel - C - up to stop.





- After installing compressor, check installation position of boot - A -.