Rear Axle Toe, Adjusting

Rear Axle Toe, Adjusting

- Install underbody trim - 1 - in front of trapezoidal control arm.





Convertible only

- Remove diagonal brace - 1 - or - 2 - on side with toe to be adjusted. Refer to => [ Front or Rear Diagonal Braces ] Rear Suspension.





Continuation for all vehicles

- Remove front interior trapezoidal control arm/subframe connection nut - C -.





- Adjust toe accordingly by turning eccentric bolt - D -.

- Install new nut - C - and tighten.

• The maximum adjustment range is 90° to left or right of center position.

• The geometric drive axle is automatically changed when individual toe settings are changed.

- After tightening nut - C -, check toe value again.

Convertible only

- Install diagonal brace. Refer to => [ Front or Rear Diagonal Braces ] Rear Suspension.

Continuation for all vehicles

- Install underbody trim.