ATF, Changing or Topping Off After Repairs [01V]

ATF, changing or topping off after repairs

Special tools, testers and auxiliary items required



- Drip tray VAG1306



- ATF filler tool VAG1924

Procedure
- Engine switched off.



- Secure container of ATF filler tool VAG1924 as high up on vehicle as possible.
- Raise vehicle.



- Remove noise insulation panel (arrows).

Note:
- Observe disposal regulations.
- Engine must not be started without ATF and vehicle must not be towed!

- Place Drip tray VAG1306 under transmission.



- Remove drain plug (arrow - 1 - ).
- Let ATF drain.
- Tighten new drain plug (arrow - 1 - ) to 40 Nm.

Note:
- Drain plug and oil seal must both be replaced.

- Remove ATF check plug (arrow - 2 - ).



- Insert ATF filler tool VAG1924 into an opening (arrow) in the protective cap, but do not knock cap upward.



- Fill with ATF using ATF filler tool VAG1924 until ATF exits from the check hole.
- Shift selector lever into position "P" .
- Start engine.
- Keeping the brake pedal depressed, shift into all selector lever positions at idle speed. Each position must remain selected for at least 10 seconds.
- Shift selector lever into position "P" .
- Check ATF level and top off.
- Install noise insulation.

Note:
- Observe all notes and test requirements for "Checking ATF level" .