Measured Value Block Table

Measured Value Block table - 01J, Continuously Variable Transmission (CVT)

Display Group Number 001:

1) While driving: a second technician is needed to read the specified values.

Display Group Number 002:

2) While driving: a second technician is needed to read the specified values.

Display Group Number 003:

4) You must activate the upshift switch (+) by tapping the selector lever forward. On vehicles with multi-function steering wheel the upshift switch has to be activated by additionally tapping the upper left or right button (+) on the steering wheel.
5) You must activate the downshift switch (-) by tapping the selector lever to the rear. On vehicles with multi-function steering wheel the downshift switch has to be activated by additionally tapping the lower left or right button (-) on the steering wheel.

Display Group Number 004:

2) While driving: a second technician is needed to read the specified values.

Display Group Number 004:

2) While driving: a second technician is needed to read the specified values.

Notes on display group number 004:
^ If "0 RPM" is shown in display field 3 or 4, the corresponding sender is faulty and the Transmission Control Module (TCM) must be replaced.
^ If "0 RPM" is shown in display field 3 and 4, there is a mechanical defect in the transmission, and the transmission must be replaced.

Display Group Number 005:

Display Group Number 005-006:

Display Group Number 007:

2) While driving: a second technician is needed to read the specified values.

Display Group Number 007:

2) While driving a second technician is needed to read the specified values.

Note on display group number 007, display field 4:
^ If "AS" is always displayed, the clutch is slipping. The ATF must be changed. If "AS" is still displayed the transmission must be replaced.

Display Group Number 008:

2) While driving a second technician is needed to read the specified values.

Display Group Number 009:

2) While driving a second technician is needed to read the specified values.
6) In order to generate the Kickdown signal the accelerator pedal must be depressed to the stop.

Display Group Number 010:

7) "ADP" is the abbreviation for adaptation. Adaptation means adapting to an internal specified value.

Display Group Number 011:

7) "ADP" is the abbreviation for adaptation. Adaptation means adapting to an internal specified value.

Display Group Number 012-017:

2) While driving a second technician is needed to read the specified values.

Display Group Number 018-020:

Display Group Number 022:

2) While driving a second technician is needed to read the specified values.

Display Group Number 022-124:

2) While driving a second technician is needed to read the specified values.

Display Group Number 125:

Notes on display group number 125
^ If "1" is displayed, communication from the corresponding control module to the Transmission Control Module (TCM) is O.K.
^ If "0" is displayed and no trouble code has been set in the DTC memory, the corresponding control module does not have CAN capability (or is faulty).