Rear Lid Lettering, Sedan

Rear Lid Lettering, Sedan

from VIN 400 001

• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.

Installation:

- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters - 1 -, maintaining pressure for approx. 3 seconds.

Dimensional data for Front-Wheel Drive (FWD) vehicles





• a = 23 mm.

• b = 28 mm

• c = 2 mm

• d = 28 mm

• e = 11 mm

Dimensional data for All Wheel Drive (AWD) vehicles





• a = 23 mm.

• b = 28 mm

• c = 4 mm

• d = 12.5 mm

• e = 28 mm

• f = 11 mm

from VIN 400 001

• Lower edge of rear lid is used as a reference edge, outer edge at crossover point for the corresponding height dimension.

Installation:

- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters - 1 -, maintaining pressure for approx. 3 seconds.

Dimensional data for Front-Wheel Drive (FWD) vehicles





• a = 25 mm

• b = 30 mm

• c = 63 mm

• d = 25 mm

Dimensional data for All Wheel Drive (AWD) vehicles





• a = 25 mm

• b = 30 mm

• c = 63 mm

• d = 25 mm

• e = 4 mm