Clean Working Conditions

Clean Working Conditions

• Thoroughly clean all connections and the surrounding area before disconnecting.

• Place parts that have been removed on a clean surface and cover. Use foils and paper. Use lint-free cloths only!

• Carefully cover over opened components or seal, if repairs are not carried out immediately.

• Only install clean components: Only unpack replacement parts immediately prior to installation.

• Always replace O-rings, gaskets and sealing rings.

• Lightly lubricate O-rings before installing, this prevents the rings from being pinched when inserting.

• Use only ATF in areas near ATF. Other lubricating substances cause functional problems in the hydraulic transmission control.

• Check the following fluid levels after installing, top off if necessary. Refer to ATF in planetary gear => [ ATF Level, Checking ] [1][2]ATF Level, Checking, gear oil in front final drive => [ Front Final Drive Gear Oil, Checking ] [1][2]Front Final Drive Gear Oil, Checking, gear oil in center differential => [ Center Differential Gear Oil, Checking and Filling ] . Capacities and specifications => [ Capacities ] 01VA Transmission onward.