Tower 1

Tower 1

Disassembling

- Remove lifting device (T10287) from tower "I".





- Remove clutch "D/G" - 2 - from clutch " F" - 1 -.





- Remove clutch "F" - 5 - from planetary gear "III" - 1 -.





• Thrust washer - 2 -, axial needle bearing - 3 - and angle washer - 4 - remain on planetary drive " III".

Assembling

- Place planetary drive "III" - 1 - in mounting device (T10282).





- Lay thrust washer - 2 -, axial needle bearing - 3 - and angle washer - 4 - on planetary drive " III" - item 1 -.

• Angled edge of angle washer faces planetary drive "III".

- Attach clutch "F" "item 5" onto disc carrier of planetary gear - III - - 1 -, using short lifting/turning motions.

• All clutch discs "F" must engage one after another in planetary drive disc carrier "III".

- Check whether all plates are engaged, to do so lift clutch " F" a few millimeters and let fall.

• If this produces a metallic sound, all plates are engaged.

• If only a muted sound is heard, not all plates are engaged.

- Place clutch "D/G" - 2 - onto plate carrier on clutch "F" - 1 -, using short lifting/turning motions.





• All clutch discs "G" must engage in sequence in plate carrier of clutch "F".

- Check whether all plates are engaged, to do so lift clutch " D/G" a few millimeters and let fall.

• If this produces a metallic sound, all plates are engaged.

• If only a muted sound is heard, not all plates are engaged.

Install lifting device (T10287) as follows:





- Turn back knurled nut of lifting device.

- Insert lifting device into tower "I" until stop.

- Tighten knurled nut of lifting device in clockwise direction.

- Check lifting device in tower "I" for proper seating.