Planetary Gear Component Overview

Planetary Gear Component Overview

• Some of the depicted components are part of component groups and are not available separately as replacement part.





1 Bolt, 10 Nm

2 Sealing washer

• Replace

3 O-ring

• Replace

4 ATF supply

• With ATF pump

• Disassembling and assembling, refer to => [ Clutch ] Clutch

5 Axial needle bearing

6 Rectangular rings

• Replace

7 Rectangular ring

• Replace

8 O-rings

• Replace

9 Adjustment shim

• Determine thickness => [ Insert with dial gauge extension onto input shaft of transmission,
as depicted in illustration. ] Planetary Gear

10 Tower "II"

• Disassembling and assembling, refer to => [ Tower 2 ] Tower 2

11 Thrust washer

12 Axial needle bearing

13 Thrust washer

14 Intermediate shaft with inner plate carrier

15 Angle washer

16 Axial needle bearing

17 Thrust washer

18 Sun shaft

19 Axial needle bearing

20 Sun gear "I"

• Magnetic, for transmission with hydraulic control "E17", Transmission Input Speed (RPM) Sensor (G182) is then an inductive sensor

• Not magnetic, for transmission with hydraulic control "E18/2 ", Transmission Input Speed (RPM) Sensor (G182) is then a Hall sensor

21 Planetary gear set "I" and "II"

22 Angle washer

23 Axial needle bearing

24 Thrust washer

25 Shaft with ring gear "I"

26 Ribbed cup

27 Thrust washer

28 Axial needle bearing

29 Angle washer

• Height 2.5 mm incl. collar

• Do not interchange with angle washer => [ (Item 33) Angle washer ]

30 Circlip

31 Fitting key

32 Tower "I"

• Disassembling and assembling, refer to => [ Tower 1 ] Tower 1

33 Angle washer

• Height 5 mm incl. collar

• Do not interchange with angle washer => [ (Item 29) Angle washer ]

34 Axial needle bearing

35 Angle washer

36 Sun gear "III"