Zero Adjustment for Sunroof Operation, Adjusting

Zero Adjustment for Sunroof Operation, Adjusting

• A zero adjustment is necessary, if

• Sunroof motor was not removed in zero position.

• Sunroof was opened or closed via emergency operation.

• Parts of sunroof operation were removed and installed.

- Remove trim. Refer to => [ Slotted Guide Rail Cowl Panel Trim ] Slotted Guide Rail Cowl Panel Trim.

- Close sunroof.

- Slide sunroof headliner completely toward rear.

- Remove sunroof motor. Refer to => [ Sunroof Motor ] Sunroof Motor.

- Left and right guide pin - 1 - must be located centered to marking - 2 - on guide plate.





• Illustration depicts glass sunroof panel as removed.

- Connect the voltage supply connector - 4 - to the removed sunroof motor.





- Connect the connector - 1 - to the sunroof switch inside the interior lamp.

- Select "roof opened" or "roof tilted open" using rotary switch.

• Motor automatically runs to end position

- Move rotary control to "roof closed" position.

• Motor automatically runs to zero position and switches off - markings - 2 - and - 3 - must lie opposite each other

- Install motor in this position with sunroof closed.