Compressor Drive Shaft

Compressor Drive Shaft

Removing

- Remove the compressor (vehicles with 8-cyl. engine), => [ Compressor, 10-Cylinder ] (vehicles with 10-cyl. engine).

- Remove boot - A -





- Remove driveshaft - B - from splines of drive pinion - C -

Installing

Installation is carried out in the reverse order, when doing this note the following:

- Check driveshaft - B -, splines must show no traces of wear and must be seated free of play in splines of drive wheel - C -.

- Coat the driveshaft splines - B - with grease (G 000 100) before inserting.

- Insert driveshaft - B - before installing compressor and slide it into drive wheel - C - up to stop.





- After installing the compressor, check the grommet - A - installation position and the installed clamp.

A clamp on the power steering pump prevents the grommet - A - from slipping off. The clamp was used in production from MY 2005. Install it if necessary.