Operation CHARM: Car repair manuals for everyone.

Allroad Trim







Allroad Trim

The trim can only be replaced, removal without destruction is not possible.

Remove adhesive residue on body if necessary.

Clean adhesive areas on body with Cleaning Solution (D 009 401 04).

Adhesion surfaces must be free of dust and grease.

Warm body in adhesive areas and trim to approximately 40° C before bonding.

When installing, the trim must be applied according to the contours. It is not possible to make corrections later.

Fender Trim, Replacing





1 Trim

To remove, warm adhesive points with hot air gun and gradually pull off trim.

Position according to contours when installing and gradually press on firmly by hand.

2 Adhesive tape

Pull off protective foil before installing

Lower A-pillar Trim, Replacing





- To remove, warm adhesive points with hot air gun and pull off trim.

- Remove protective foil from adhesive bands - 2 -.

- When installing, apply trim - 1 - according to contours and gradually press on firmly by hand.

Side Panel Trim, Replacing





1 Rear door trim

To remove, warm adhesive points with hot air gun and gradually pull off trim.

Position according to contours when installing and gradually press on firmly by hand.

2 Side panel trim

3 Adhesive tape

Pull off protective foil before installing