Lock Lever and Lock Cylinder

Lock Lever and Lock Cylinder





1 Lock lever

• Removing

- Push latch lever - 1 - in direction of arrow and remove screws - 2 - (Qty. 2).

- Lift latch trim - 3 - off.

- Use a screwdriver to disengage locking hooks (Qty. 2) of latch lever on inside of latch trim.

- Remove lock lever on outer side.

• Installing

To install, perform the steps used in removal in reverse order.

2 Screws, (Qty. 2)

3 Latch trim

4 Release pin

• When backrest is locked, pin projects 1-2 mm over latch trim.

• When backrest is unlocked, pin projects about 20 mm over latch trim and a red marking is visible.

5 Lock cylinder

• To remove and install the lock cylinder, you must insert the ignition key.

• Removing

- Insert ignition key and remove lock cylinder - 5 -.

• Installing

To install, perform the steps used in removal in reverse order.