Removing

Removing

NOTE:
- On removal, note down bolt lengths and assignment for re-installation.
- All cable ties and other wiring harness fasteners released or cut open on removing air conditioner unit are to be re-attached in same position on installation.

- Drain refrigerant circuit:
- Switch ignition on.
- Move power seats to rearmost position.
- Switch off ignition.
- Remove dust and pollen filter
- Remove E-box cover and engine control module.
- Remove dome brace with reinforcement to cowl panel trim.
- Remove windshield wiper completely.
- Remove pump valve unit.
- Protect driver and passenger seat using seat cover.
- Disconnect negative terminal clamp from Battery A.

NOTE:
- Before disconnecting Battery A, obtain anti-theft radio security code if necessary.
- On vehicles with electrically adjustable seats, move the seats back as far as possible before disconnecting the Battery A.

- Remove dash panel complete with dash panel cross member.
- Remove brake master cylinder and brake booster.
- Remove complete foot pedal assembly with mounting bracket.
- Disconnect refrigerant lines from evaporator connection.
- Remove Rotation Rate Sensor G202







- Remove brackets - A - and - B - (depending on A/C unit version, only brackets - B - or - A - are installed).
- Remove air guides to footwell vents.
- Disconnect evaporator drain hoses from heating and A/C unit
- Disconnect harness connectors to heating and A/C unit.







- Remove bolts - A -.
- Remove bolts - B -.
- Remove A/C unit toward vehicle interior.