Directional Stabilization Assistance Control Module and Lens Screen

Directional Stabilization Assistance Control Module and Lens Screen

Removing

- Remove the cover trim - 1 - down from the bracket in the - direction of the arrow -.





- Press the retaining clamp - 1 - forward in the - direction of the arrow - and remove the directional stabilization assistance control module (J759) sideways and down from the bracket.





- Disconnect the electrical connector and remove the directional stabilization assistance control module.

- Press the clamps - arrows -, pull the lens screen out of the bracket and remove it toward the rear.





Installing

Installation is performed in the reverse order of removal. Observe the following when doing so:

• The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using a cleaning solution (D 009 401 04).

• If the directional stabilization assistance control module is replaced, the camera and the control module must be re-calibrated. Refer to => [ Lane Assist Calibration ] Lane Assist Calibration.