HID Headlamp Ignition Coil, Through 08.07

HID Headlamps

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Adjust the headlamps after performing any work that could have affected their adjustment.

HID Headlamp Ignition Coil, through 08.07

Removing


Danger to life due to high voltage.

• Observe usage and safety information for gas discharge headlamps.

- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Loosen locking bolt - 1 - a few turns.





- Remove appropriate front wheel.

- Remove appropriate front wheel housing liner.

- Release retainer tabs - arrows - and detach low beam housing cover from headlamp housing.

- Disconnect harness connector - 1 - at ignition coil for gas discharge lamp.





- Turn ignition coil - 2 - for gas-discharge lamp counter-clockwise - arrow - and detach.

Installing

Install in reverse order of removal, observing the following:

• Harness connector must only be connected with ignition coil installed.

- Check if recess in housing of ignition coil for gas discharge lamp and recess in pressure ring align completely with each other - arrows -.





- Attach ignition coil for gas discharge lamp to headlamp and fasten clockwise until stop.

• Ignition coil must turn freely.

• Arrow on housing points upward.

- Connect harness connector.

- Close housing cover and secure with screw.

- Install front wheel housing liner.

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.