Oil Level Sensor For ECM: Service and Repair

Oil Level Thermal Sensor G266, removing and installing

Removing

Note:
^ Before raising the vehicle on a hoist (wheels off the ground), first activate the vehicle jack mode.

For vehicles with parking/auxiliary heater:





- Remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.

All





- Loosen mounting parts - 1 - and remove noise insulation.
- Place oil receptacle beneath.
- Drain engine oil.





- Disconnect electrical harness connector at Oil Level Thermal Sensor G266 - 1 -.
- Remove Oil Level Thermal Sensor G266.

Installing

Note:
^ Replace seals.

- Clean sealing surfaces, must be free of oil and grease.





- Apply sealant to studs of oil pan - arrows -.
- Sealant
- Install Oil Level Thermal Sensor G266 - 4 -.
- Connect electrical wire - 3 -.
- Add engine oil and check oil level.
- Install sound insulation.

Torque specifications