Humidity Sensor, With Lane Assist

Switches

Humidity Sensor, with Lane Assist





- If the humidity sensor (G355) was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided Functions".

- Pry the top cover - 1 - from the interior rearview mirror base - arrows -.

- Remove front interior light. Refer to=> [ Front Interior Lamp with Roof Electronics Control Module, from 09.07 ] Front Interior Lamp with Roof Electronics Control Module, from 09.07.





- Remove interior mirror.

- Remove screws - arrows -.

- Unclip cover for sun visor center support and remove bolts.

- Remove the sun visor center support.

- Unplug connector - arrow - at front interior light.





- Guide Humidity Sensor (G355) electrical wires between molded headliner and body.

- Spread the cover - 1 - apart slightly at both sides - arrows - and remove the humidity sensor (G355) - item 2 -.





Installing

Install in reverse order of removal, observing the following:

• After removing sun visor center support, always remove traces of locking fluid from tapped holes. Otherwise, there will be a danger of the bolts seizing and shearing off on subsequent disassembly.

• Cleaning can be performed using a tap of appropriate size.

• Replace self-locking bolts.

- Carefully place Humidity Sensor (G355) in side guides.

• If Humidity Sensor (G355)is not installed correctly, it will not be centered in hole in cover.

- Install interior mirror.

- Install front interior light. Refer to=> [ Front Interior Lamp with Roof Electronics Control Module, from 09.07 ] Front Interior Lamp with Roof Electronics Control Module, from 09.07.