Protective Molding

Protective Molding

Replacing side protective moldings

• It is not possible to remove without destroying.





1 - Front protective molding

• Removing:

• To remove protective moldings - 1 - and - 2 -, heat using a hot air gun and pull off from door.

• Installing

• Adhesion surfaces must be free of dust and grease.

• Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

• Protective moldings must be affixed only at room temperature.

• For this purpose, bring vehicle and protective moldings to room temperature at least 2 hours before processing.

• Protective moldings must be adhered within 90 minutes after protective foil has been removed.

• Pull protective foil from double-sided adhesive tape shortly before installation.

• Apply protective molding to be adhered at front and adhere working toward rear.

• Heat protective molding to approx. 40°C using heat gun and forcefully press on or roll on.

• After adhering strip, leave vehicle 4 hours in room temperature.

2 - Rear protective molding