Storage Compartment From Right Trim With Switch Panel, Removing and Installing

Storage Compartment From Right Trim With Switch Panel, Removing And Installing

Special tools, testers and auxiliary items required







- Trim removal wedge 3409







- Hook 3438

Removing
- Open coin tray.
- Slide trim for storage compartment to left - arrow - out of fastener and remove.







- Open glove box.
- Starting from above glove box, separate trim panel - 1 - with switch module from instrument panel using Trim removal wedge 3409.







- Remove trim panel with switch module in direction of - arrow -.

NOTE: Take particular care when unfastening clip on driver side end of trim panel.

- Disconnect connector.
- Turn selector wheel - 3 - of left air vent above glove compartment fully up.
- Above bottom slat - 2 -, insert two 90 degrees pick tools - 1 - in each two air vent clips.
- Alternating between left and right side, pull air vent out of opening, taking care to ensure that 90 degrees pick tools remain in position.







- Disconnect connector at air vent.
- Release retainer tabs - 1 - of storage compartment.
- Remove storage compartment from instrument panel in direction of - arrow -.







- Disconnect connector on back of storage compartment.

Installing
Install in reverse order, note following:







- On installing trim panel - 1 - with switch module, make sure both catches are inserted in center of trim panel between instrument panel and monitor housing - arrows -.